The bent and straight turnbuckle brace allows you to easily adjust the length of your brace to bring your wall to plumb.

Support from the ground up

Form braces run at an angle from the top of the form to the ground,
provide support and keeps the walls plumb. Turnbuckle braces and
attachment plates are used along with 2×4 lumber to brace the
form.  Pipe braces care a telescoping system that provide a
one piece bracing solution.

 

Easily adjust your bracing

Ellis Formwork Manufacturing Co’ most common brace is the turnbuckle
brace. The turnbuckle brace allows you to easily adjust the length
of your brace to bring your wall to plumb. The turnbuckle brace
uses a 2×4 piece of lumber that runs from the ground to your form
to push or pull your form. The turnbuckle has a bent end plate on
one end which allows it to be easily fixed to a stake in the
ground, or to the  waler.

 

Attach using existing hardware

Straight end braces allow 2×4 lumber to be attached directly to the
form using available wedge bolt slots and wedge bolts. The straight
end plate can also also be attached to a stake nailed in the
ground.

 

Turnbuckle Brace
Bent End Plate
    Weight    
One Size   7.0lbs  
Straight Plate
    Weight    
One Size   7.0lbs  
Attachment Plate
Size
    Weight    
One Size   1.2lbs  
Pipe Brace
Sizes
    Weight    
(E-1) 7’6″ TO 14′ (Low Wall)   75.0lbs  
(E-4) 14′ TO 23’6″   130.0lbs  
(E-5) 23′ TO 39′   208.0lbs  
Replacement Parts
E-4 Parts
    Weight    
Inner Pipe   44.0lbs  
Outer   76.0lbs  
Swivel   3.6lbs  
Shoulder Nut   2.0lbs  
Threaded Rod   9.0lbs  
E-5 Parts
    Weight    
Inner Pipe   76.0lbs  
Outer   105.0lbs  
Swivel   3.6lbs  
Shoulder Nut   2.0lbs  
Threaded Rod   9.0lbs  
Misc. Parts
    Weight    
Shoes   4.0lbs  
“L” Pin   1.0lbs  
“L” Pin Clip   0.1lbs  
All material © 2007 by www.ellisforms.com. All rights reserved.

info@ellisforms.com

Powered by webEprint